+123 456 4444


The device list in your software may not be up to date with the latest printers available. To install memory expansion modules Make sure that the printer is switched off and that neither the power cord nor an interface cable is connected. Configuring the SunOS 4. They are listed in preferred order:. The application “SignGO” has drivers for just about every device.

Uploader: Shalar
Date Added: 28 April 2017
File Size: 29.46 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 83809
Price: Free* [*Free Regsitration Required]

Your application software needs to know to which type of printer it is sending information. Europe, Middle East, Africa.

Does the image appear in the size, orientation, and position on draftmastwr sheet that you expected? All application users need read and write permission for this directory.

HP Computer Museum

The power cord supplied with your printer should meet the plug requirements for your area. Press the up arrow next to the front panel display to indicate you are loading a sheet. For the HP DeskJet C Plus printer, each stall in the carriage has a dot indicating the color of the cartridge that should be installed. Push the end cap back in, making sure that the tabs are flush against the ends of the roll. I made up a holder on my mini-lathe for an exacto swivel knife out dravtmaster delrin that works ok but I am thinking there might be something better.

The software results page for your printer displays with the default operating system selected. Driver for Microsoft Windows 95 and 3. On sheet media, wait until the ink is dry, if necessary see the front panel display for an ink-drying messageand then gently pull the sheet out from the printer.


In most cases, you do not need to add the drfatmaster for each individual software application just once for all Microsoft Windows applications, for example.

When the calibration procedure is complete, the message Calibration complete will display. This knowledge, and other configuration information, is held in a “driver. If you received any item in a damaged condition, notify the dealer or HP Sales and Support Office where you purchased the printer and file a claim with the carrier.

Raise the paper-loading lever. Modify your browser’s settings to allow Javascript to execute. It is essential to load the cartridges with the printer switched on; otherwise, you eraftmaster get poor print quality, and the reliability of your cartridges will be impaired. The cut edge of the media should be along the left side of the plotter.

Do so until the message disappears.

To achieve the best performance from your printer, we recommend you use only genuine HP interface cables, whose reliability and performance have been thoroughly tested to give trouble-free performance. By default, they are dractmaster to the factory settings shown in the table above.

Install the firmware in your printer.

Choose your driver disk sread the instructions on the label, and follow any printed instructions accompanying the disks. Basic terminology Application software: To load a sheet You can load a sheet in either portrait or landscape orientation.


If the calibration fails, the message Calibration failed will display. Load a black drafting pen in stall 8 of the pen carousel. Except on glossy media types, the printer will operate successfully in monochrome with just the black cartridge loaded; these instructions assume that you are loading all four cartridges. For example, up the command line of a shell, type: If Full Menus is displayed instead of Short Menus, you can skip this step and go to step 2.

Then align the left and right edges of the media so that they are flush with the edges of the roll. draftmater

HP DraftMaster I, II, SX, RX and MX Plotters – Plotter Calibration | HP® Customer Support

Use their documentation to find the requirements. Javascript is disabled in this browser. The knife is a tight fit in draftmastfr delrin and height adjustment is by friction.

Press the down arrow next to the front-panel display to indicate you are loading a roll.